installation. Can accommodate 1 x 200ns delay, 1 x
delay, 1 x l~s delay or a combination of one 200ns
and one 500ns delay. PCB III x 60mm approx. DD
DDMI 8.638(82). DDHB 8.377(82).
NICAM 3 Multiplex Connector. Ribbon cable assembly used on
CD2M/17 and CD3M/33 when fitted with multiplexer or
demultiplexer. "A" version is used with GE7/9 and UN16/8
and "B" version is used with GE7/13 and UN16/9. "B"
version is also used with UN16/8 in a monitoring decoder.
Parent equipment CD2M/17, CD2M/33, CD2M/23. DD 1982.
otentiometer Mounting. Printed
potentiometers. ISEP 3U x 7" Long.
SCPD OBU 1982.
Delay Line Mounting. Pcb for mounting video delay lines.
A 200ns fixed delay and a 235ns programmable delay can be
mounted. Circuitry is provided for fine adjustment. To be
used instead of MP2/ll in areas of restricted height e.g.
when mounting J width boards. Pcb 95 x 55mm approx. DD
1982. DDMI 8.647(83). DDHB 8.387(83).
Multi-Microphone Box. Die-cast box with seven 3-pin XLR
microphone sockets and fixed 26-pin plug for 7 core
microphone cable. Drawing No. SP30lll. 360 x 160 x 90.
Voltage Level Detector. Voltage comparator circuit which
checks control voltage from fader and lights lamp to
indicate the fader is off normal. Power requirements :t12
volts 25mA. Printed circuit board 100 x 40. Parent
equipment PA6/87. DD 1983.
17 Pole Connector Mounting. Accepts two 17 way connectors
on CH1/65A 2U chassis. 53mm wide. To fit on rear of
PN3/55. SCPD 1983.
Processor L.E.D. Board. Unequipped board to hold up to
LED t S and mount behind an tAt wid th chassis front panel.
Intended for use with the UN26/22 and UN26/22A (G.P.
Processor board) as a component part of specific units. DD
Processor Switch Board. Unequipped board to hold up to 2 x
8 pole D.I.L. switches and three LED'S and to mount behind
an 'A' width chassis front panel. Intended for use with
the UN26/22 and UN26/22A (G.P. Processor board) as a
component part of specific units. DD 1983.
Filter Control Unit. Controls and switches tuning voltage
to FL2/26. Power requirements +15 volts DC at 7mA. PC
board 35.5 x 28.5mm. Parent equipment RC4M/8D. DD 1983.
Monitor and Control Interface.
1. Provides a means for monitoring the audio input and
output of OB Audio Equaliser;
2. An interface for local control of OB Audio Equaliser by
plug-in Control Panel. 3U unsupported card. Parent
equipment EQ3M/38. DD 1983.