AM070513 AM7L/513
AM070514 AM7/514
AM080012 AM8/12A
AM080015 AM8/15
AM080017 AM8/17
AM080018 AM8/18
AM080019 AM8/19
The monitoring output is also modified to give a 1 volt
output whatever the amplifier gain is set to. Power
requirements 240V AC. CH1/64A. Parent equipment AM7L/513.
Sub-units PA20/512A. SCPD OBU 1982.
Line Sending Amplifier. Comprises
PA20/510A. Power requirements 240V
CH1/64A. SCPD OBU 1982.
of AM7/512A and
AC. PN3A/79A &
27 Mbytes/ s Parallel Interface Regenerator. This unit is
required to extend the transmission distance of the
27 Mbytes/s bytes/s EBU parallel interface for digital
video signals. It amplifies the received video and clock
signals and a phase locked loop is used to regenerate the
clock signal. This is used to retime the video data
signals before they are transmitted with the regenerated
clock. Basic alarm facilities which monitor the status of
the input data signals, clock and power supplies have bee
included.
Power
requirements
240
V
ac.
BMM
Chassis.
Termination
Panel:
PA20/529.
DDMI
1.288(86).
DDHB
1.207(86). DD 1984.
Loudspeaker Amplifier. As AM8/12, but fitted with XLR
connector for i/p and o/p. (Change initiated to H.H.
Electronics manufacture). Metal Box,
97/8" x 61/4" x 31/2". DD 1984.
Frequency Splitting Power Amplifier. Low level frequency
splitting amplifier combined into a modified QUAD 303A
Power Amplifier for use with LS3/7 O.B. Loudspeaker.
Delivers a 28 watts into l6Q. Delivers 45 watts into 8Q.
Power requirements 240V 1 amp maximum. Equipment
supersedes AMI/53, AM8/14. ED 1977.
Loudspeaker Amplifier. Mono SO W Loudspeaker Amplifier
with -20dB programme sensitivity. Power requirements 200-
250V AC at 100VA and/or ~24V DC at SOW. Mounting metalwork
FW1/17 and/or PN1/41. DDMI3.728(84). DDHB 3.295(84).
EDI 10494(1)AUG 84. DD 1982.
Dual Loudspeaker Amplifier. First developed for Outside
Broadcast communications in television. Each amplifier has
six
actively balance
inputs.
Virtual
earth
inputs
are
available for use with an unbalanced signal matrix. The
gain of each amplifier and overall 'high normal cut'
volumes are remotely controlled. A band pass filter can be
switched into circuit by a front panel control which
reduces any incoming LF or HF noise. This can be
overridden remotely. Monitoring push buttons connect each
output to a buffered bus bar. The bus bar can be connected
to other units and to a signal monitoring system. Power
requirements ~16V 160mA quiescent. 100mm x 220mm Eurocard.
Mounted on 0.6" width front panel for 3U high racking with
96 way Euro-connector. Supersedes AM5/18. SCPD 1983.
Loudspeaker Amplifier. General purpose loudspeaker
amplifier designed as a replacement for the AM8/12. It
uses a Quad 405 amplifier circuit board and has similar
13

13