AP010014 AP1/14A,B,H
AT020014 AT2/14
AT02001S AT2/1S
AT020016 AT2/16
AT020017 AT2/17
AT020018 AT2/18
AT030S12 AT3/S12
AT040S14 AT4/S14B
requirements :!:S V, -18V unstabilised at 260 mA each. 4U
unsupported card. DD 1984.
Apparatus Connector. This connector is a 2U printed
circuit board termination panel in 3 widths A(S3mm),
B(106mm),
and
H( 426mm).
It
accepts
17
way
Souriau
socket(s) and a 4 pole miniature mains connector if
required. DD 1978.
Fader Module. Provides control of system gain in mono
versions of the RP2/10. Power requirements :!:lSV 30mA. 2U
unsupported card. Parent equipment RP2/10. DD 1977.
Fader Module. Provides control of system gain and balance
in stereo versions of RP2/10. Power requirements :!:lSV
30mA, +SV 20mA. 2U unsupported card. Parent equipment
RP2/10. DD 1977.
Muting Unit. Momentarily attenuates the signal passing
through the RP2/10 during the run-up time of the turntable.
Mute duration is adjustable by edge-mounted potentiometer.
Power requirements :!:lSV 16mA, +SV 80mA. 2U unsupported
card. Parent equipment RP2/10. DD 1977.
Attenuator Module. This is one of a range of optional
modules for the AM16M/16 (part of RP2/10). It produces up
to 10dB switched attenuation in 2dB steps. Attenuation is
remotely controlled by digital signals from PA6/96. Power
requirements +36V, +SV. 2U unsupported card. DD 1978.
Audio-Frequency Attenuator. Attenuates input
to commercial Compressor/Limiter. This unit
AM7/12 plug into EP2M/7C when the AM6/18 is
CH1/6SA. Parent equipment EP2M/7C. SCPD 1980.
signal
and an
removed.
Video Attenuator. The unit comprises two 7SQ attenuators,
each having a range of 1dB in O.ldB steps and is used for
equalising the levels at the inputs of a diversity switch.
Code pins 1, 21, 29. CH1/64A. DD 1980.
6dB UHF Attenuator. This is an addition to the AT4/S14
series. It is mechanically the same as the "A" version and
is intended for general use at frequencies up to lGHz. DD
1977 .
28

28