AM040536 AM4/536
AM040537 AM4/537
AM040538 AM4/538
AM040539 AM4/539
AM040540 AM4/540
AM050007 AM5/7
AM050015 AM5/15B
AM050020 AM5/20
AM050021 AM5/21
6 dB Video and Pulse Distribution Amplifier. Distribution
amplifier with 6 dB gain and 6 outputs at nominal 1 V p-p.
Power requirements :t18 V 150 mA unstabilised. 4U
unsupported
half-card.
Supersedes
AM4/531
(in
most
applications). DD 1981. DDMI 8.628(82). EDI 10407(2) OCT
81. DDHB 8.372(81).
15 dB Distribution Amplifier. Distribution amplifier with
15dB gain and 6 outputs at nominal IV p-p. For
applications where AM4/536 has insufficient gain. Power
requirements :t16V 120mA. 4U unsupported half-card. DD
1981.
3 Channel 6dB Distribution Ampliifer. This unit will
contain three separate four output distribution 6dB
amplifiers, closely matched. It is constructed in a
CH1/64A chassis and is mains powered. This amplifier is
suitable for RGB or YUV operation. Power requirements 240V
mains. CH1/64A. Supersedes AM4/532. DDMI 8.652(84). EDI
10491(1)MAR 85. DD 1983. EDI 10491(1)MAR85.
Video Output Amplifier. Output Amplifier used in the
RC5M/503. It provides four video programme outputs and one
monitoring output and also generates a voltage for
adjusting the IF frequency response in the DM2/514. Power
requirements :t16 V dc. CH1/86. Parent equipment RC5M/503.
DD(5) 1985.
Video Distribution Amplifier. Video Distribution Amplifier
incorporating Low Pass Filter, providing 4 video outputs.
Power
requirements
:t12
V.
CH1/86.
Parent
equipment
DM1M/506. DD 1984.
General Purpose Amplifier superseding AM9/8. Gain: pre-set
10dB
to
40dB.
Output:
+12dB
maximum.
Across
1200Q.
Printed circuit board 57mm x 40mm. DD 1969. DD Spec
3.495. DDHB 3.141. ACO.
Channel Amplifier. Channel amplifier used as subunit in
PA8/411. Provides 1 pre fader and 2 post fader outputs.
It is mechanically and electrically compatible with the
AM5/15
but has
9dB
gain
in pre-fader
output.
Power
requirements -24V dc. PCB 101.5 x 89.0. Parent equipment
PA8/411. SCPD 1981.
Intercom Power Amplifier providing 2 watt output into load
of 8 ohms or higher. Extended heat sink will permit up to
10 watts output power. For -24V and -50V operation.
Printed circuit board l27mm x 75mm with ISEP 11 way plug.
DD
1977.
DDMI
3.643(77).
DDHB
3.193(77).
EDI
10307(P)APR77.
General Purpose Amplifier. Intercom power amplifier
providing 2 watts output into a load of 8 ohms or higher.
Extended heat sink permits up to 10 watts output power.
For -50V, and -24V operation. Operation on +12V, +24v also
possible. Printed circuit board to be mounted in CH1/65A,
provision for input transformer and gain control, to be
5

5