PN030066 PN3/66
PN030067 PN3/67
PN030069 PN3/69A-H
PN030070 PN3/70A-H
PN030071 PN3/71A,B,D
PN030072 PN3/72
PN3/72A&B
PN030073 PN3A/73
PN3/73
PN030074 PN3A/74
PN3/74
in place of PN3/23C where suitable jacks are available on
jackfields. DD 1966. DD Spec 3.490.
Decoder Panel. Rack to house a variable number of Pilot
Tone Demodulators DM1/2A and DM1/2B, AM6/19, DM1/5. Number
and
type of units variable according
to
site.
used
in
Monitoring and Information Centre, and Monitoring and
Collection Points. Power requirements :t5V, +9V. PN3/23.
DD 1978.
General Purpose 2U Panel based on PN3/55. Recessed
equipment mounting plate, rear connector plate (both
undrilled), and screw-on front cover. Basic metalwork from
which relay panels, transformer panels etc. can be derived.
SCPD 1978.
Panel (Portable). This panel, with carrying case CS2/26A-H
and termination panel PN3A/51A-H, will allow units to be
mounted in a portable manner. No power requirements. 2U
BMM. DD 1980.
Panel (Portable). This panel with carrying case CS2/27A-H
and termination panel PN3A/50A-H, will allow units to be
mounted in a portable manner. No power requirements. 4U
BMM. DD 1980.
Panel. Back panels for use with PN3/58 and CH1/82, in A, B
and D versions, at SCPD's request. ED 1980.
1U Panel. 1U high bay mounting panel, internal size 40mm
H x 360mm D x 416mm W. Top cover part hinged for access.
Intended to house printed circuit boards on base plate
using spacers or similar. DD 1983.
1U Panel.
'A' Version. 1 U high bay mounting panel, internal size
40 mm H x 360 mm D x 416 mm W.
'B' Version. 1 U high bay mounting panel, internal size
40 mm H x 410 mm D x 416 mm W.
Intended to house printed circuit boards on base plate
using spacers or similar. DD 1985. DDMI 1.265(85). DDHB
1.193(85).
Termination Panel. This termination panel or cover fits a
2U frame (PN3/56) and consists of one end bracket for an
XLR mains connector and a cover together with a lacing bar.
Used mostly on 305mm deep bays, where the panel is to be
'hard wired' to the bay. DD 1976. DDMI 1.245(79).
General Purpose Panel. Panel to mount 5 Power Suppliers
PS3/71. Power requirements 240 Vac. 3 U main frame. DD
1985. DDMI 3.752(85).
General Purpose Termination Panel. This panel fits the
rear of a PN3/55 (2U) frame, to which it is hinged. It
would be used in addition to a normal metal or printed
circuit board back plate to carry the plugs and sockets for
external
connections.
DD
1976.
DDMI
1.194.
DDMI
3.752(85).
General Purpose Panel. Panel to mount 8 amplifiers &~7/25
224

24