PS040018 PS4/18 & A
5V at D.SA ) Isolated
12V at 0.5A )
Mechanically adapted to bolt to interior of chassis frame,
provide mains protection and connect to standard power
supply rear connectors. Power requirements 240V AC.
Switched Mode Power Supplier. This code defines the com-
binaton of a PS4/11 and an un-wired termination panel. The
termination panel is fitted with mains and power connectors
to mate with PS4/11, and the user must wire to the con-
nectors. No rear over is provided. Power requirements
mains. CH1/64E + 'A' width term. panel (Requires E width
1.267(85). DDHB 1.186(84).
Switched Mode Power Supplier. Switch Mode 24V supply for
Neve sound desk. Used as pairs in Power Chassis. First
used in Type 5 Colour Mobile Control Rooms. Power 240V AC
mains. CH1/82D. Supersedes PS2/222. Parent equipment
PS4M/16. Sub-units FL4/74 must be used at sound desk power
inputs. SCPD 1982.
Dual Power Supplier. Chassis containing two 24V lOA
Switched Mode Power Suppliers PS4/15 for Neve sound desk.
First used on Type 5 colour Mobile Control Rooms. Power
requirements 240V AC. PN3/ 58. Supersedes PS2/264. Sub-
units PS4/15. SCPD 1982.
Switched Mode Power Supplier. The unit houses a "Gould"
SMPSU type MMG24-1.4 which gives an output of 24 V at 1.4 A
0.1% worse condition
Ripple & Noise 10 mV RMS
4 KV RMS
To BS 800 PT3 & VDE 0875N
Power requirements 240 V mains. CH1/64A. TCPD 1982.
Switched Mode Power Supplier. Triple O/P Power Supply, 2 x
12V 2A, 1 x 5V lOA. Maximum total load 50W. Comprises
commercial Switched Mode Power Supply card mounted in
CHl/64A chassis with two additional 12V regulators. Two
versions: PS4/18 fitted with G06 32-way connector. PS4/18A
fitted with Erni heavy duty 11-way connector. Power
requirements mains 240V a.c. CH1/64A. DD 1982. DDHB
Switched Mode Power Supplier. Switched mode stabilised
mains power supplier which uses the Cod en type L55M513T
module. It provides two 12 V supplies at 1.8 A each and
5 V at 8 A. Designed to be pin compatible with superseded
power suppliers (see below) and therefore use identical
coding slot positions to be superseded power suppliers.
Power requirements 240 Vac. CH1/64A using one G06 32-way
equipment CD2M/17, CD3M/33, CD2M/23 etc. DD 1983. DDHB