RCOl0024 RCl/24
RCOl0025 RCl/25
RCOl0026 RCl/26
RCOl0027 RCl/27
RCOl0028 RClM/28
RCOl0029 RCl/29
RCOl0030 RCl/30
where appropriate. Power requirements +12V and -12V.
CHl/65A. Parent equipment ME6M/3. DD 1978.
60kHz Receiving Aerial. To be used with the 60kHz Standard
Frequency Receiver RCl/23. This aerial comprises an
earthed bunch of six ferrite rods, tuned circuits and pre-
amplifier. A TNC connector provides the output and power
supply
connection.
Power
requirements
10V
at
10mA
approximately. Plastic tube 305mm x 5lmm diameter. DD
1978. DDTM 5.134(78).
This unit receives and demodulates the 60kHz MSF signal
broadcast
from Rugby.
It
uses
an
integral
ferrite-rod
aerial and provides a TTL-compatible data output containing
time and date information. It is mounted in a waterproof
enclosure for outdoor use. Power requirement +15V to +20V.
Outside dimensions l75mm x l25mm x l25m excluding
connector. DD 197'8.
MSF Timecode Receiver. Receives and decodes the slow code
60kHz from Rugby, for use with the BH selector system.
Power requirements 240V at lA. CHl/64B. DD 1979. DDTM
1.157 ( 80 ) .
Band 11 Data Receiver. This Band 11 receiver is designed
specifically for the reception of data pilot within the
range 23-76kHz. A monophonic audio output is also provided
for monitoring purposes. The receiver is fixed frequency
crystal controlled. Power requirements 190-260V a.c. 10Va.
CHl/64A. DD 1979.
ENG Receiver. Purpose:
(a) Receives control signals via PO line from SCAR to
select aerials and polarisation.
(b) Receives signal strength signal from vehicle
and provides meter indication.
(c) Sends signal strength and alaram data back to
SCAR.
Power requirements 240V 50Hz. 4U BMM Chassis PN3/54 with
PN3A/55 Hinged Rear Panel.
Sub-units FLl/45,
DM3/9,
COlO/5, UN2l/52, COl/13, SE2/26, MEl/lO, COl/14. DD 1982.
DDHB 2.479(82).
Band 11 F.M. Receiver. VHF Band 11 FM fixed tuned crystal
controlled
receiver.
High
sensitivity,
medium grade.
Multiplex, audio left and right channel output signals.
Stereo pilot indication with opto-isolator output. Link
programmable tone detector with opto-isolator output.
Designed to be used with Termination Panel PA20/30. Power
requirements mains. CHl/64A. Supersedes RCl/12A. DD 1983.
DDMI 5.450(84). EDI 10486(1)JUN 85.
Synthesised Band 11 F.M. Receiver. VHF Band 11 FM
synthesiser tuned receiver. 50kHz step size. High
sensitivity, medium grade. Multiplex, audio left and right
channel output signals. Stereo pilot indication with
opto-isolator output. Link programmable tone detector with
opto-isolator output. Designed to be used with Termination
Panel
PA20/30.
Power
requirements
mains.
CH1/64A.
249

49