Data from the Steenbeck film edit bench is acquired via
RS423 electrical standards. Steenbeck drive servo control
is provided. The panel is in a box on a floor stand with
cabline. Operation of the panel is software controlled.
Power requirements +8V, 0.4A/+15V, 0.lA/-15V, O.lA
equipment RP3/515. DD 1983. DDMI 7.543(86).
control the amplitude equaliser EQ3M/38. Power
requirements :t5 volts. Full width 4U front panel. DD
control the amplitude equaliser EQ3M/38. 480 x 180 x 55.
DD 1984. DDHB 6.285(86).
Audio Phase and Delay Equaliser Control Panel.
control the audio phase and delay equalisers. Power
requirements :t5 volts. DD 1983.
Rapid Recall Panel.
to save and recall prepared
names and phrases. Used as part of the ceefax subtitling
equipment for live programmes. Power requirements 5 V
200 mA. Parent equipment EP1S/552. DD 1983.
Link-Alarm Control PaneL
Provides push-button control and
lamp indications of remotely controlled SHF link equipment
and associated alarms. Power requirements 240 Vac.
PN3/56 modified. DD 1983.
aerial bearing seletion by means of thumbwheel and push-
button switches. An analogue meter for AGC indications is
also mounted in the panel. 1U 19" panel. DD 1983.
PA6/158A & B Aerial Bearing Control Panel. Provides pre-programmed
aerial bearing selection by means of thumbwheel and
push-button swithces. An analogue meter for AGC
indications is also mounted in the panel.
Version A 2 sets of above.
Version B single set mounted on L.H.S.
1U 19" Panel. DD 1984.
VDU Control Panel.
VDU equipment for use in HF transmitter
automatic control systems.
and editing of transmission schedules, and display of
PN3/54. Parent equipment EP1S/42. DD 1984. MI C.1037(87).
HB C. 1036 ( 8 7) .
Sender Control Panel.
Equipment for automatic control of
HF transmitters, including programme source and aerial
array selection, according to a transmission schedule held
in memory. Power requirements 24v d.c. PN3/54. Parent
equipment EP1S/42. DD 1984.
Selection Control Panel.
This OSSM is designed to
replace existing module in the R.H. Wing of a type D desk.
The selection is performed by means of a fibre optic data
link to a 'DPC' and hence to the new 'NTP' router. It