UN14/549A
UN140549 UN14/549
UN14/549A
UN140550 UN14/550
UN160004 UN16/4
UN160005 UN16/5
UN160006 UN16/6A
UN160007 UN16/7A
UN160008 UN16/8
UN160009 UN16/9
requirements !5 V. 4 U unsupported card. Chassis extender
CH4/5. DD(l) 1985. EDI 10540(1) APR 86. MI 1.283(86).
Digital TV Switched Delay Unit. As UN14/549, but with a
'J' width front panel. Power requirements !5 V. 4 U
unsupported printed board with 'J' width front panel.
Chassis extender CH4/5. DD(l) 1985. MI 1.283(86). HB
1.203(86). EDI 10540(1) APR 86.
Digital TV Switched Delay Unit. Delays a Digital TV Signal
(8 bit and clock) by a switched amount up to 1.4~s. Power
requirements !5 V. 4 U Unsupported Card wi th 'J' width
Front Panel. Chassis Extender CH4/5. DD(l) 1985.
Digital TV Switched Delay Unit. As UN14/549, but without a
'J' width front panel. Power requirements :t5 V. 4 U
Unsupported Printed Board. Chassis Extender CH4/5. DD(l)
1985.
Colour Phasing Delay Unit. This unit adjusts the relative
delay between the active line (including the burst) and the
syncs of a PAL colour video signal, in response to control
signals from a sui table phase comparator. It can be used
to phase a signal at a mixing point, or to adjust
subcarrier-to-horizontal phase (S/C-H). Power
requirements 240Vac. CH1/64A. Termination Panel PA20/544.
Chassis extender CH1A/43. D&ED 1987.
Separator Unit. Separates 1 volt composite signal to IMHz
and l.6MHz frequency modulated IF signals. Used in VHF
stereo link systems. CH1/12A. DD 1977.
Mic Splitter Unit accepts multicore connector type 62GB and
provides 7 XLR connection to each quad. Used by Television
Outside Broadcasts. SCPD 1978.
MK IV Cable Splitter Unit. Break-out box for MK IV
replacement cable assemblies (PIF44/1M) used on Type 6
CMCRs. Gives connector access to mains, audio, and video
pairs, and includes mains safety interlock loop.
Supersedes UN16/6. SCPD/TOBS 1985.
Commentators Splitter Unit. Accepts MK4 camera cable and 7
pair quad multicore on 62 GB connectors. Allows connection
of 2 Commentators units to CMCR. Also contains Talkback
Microphone Mixing Amplifier and Two Max components. Mains
powered via MK4 connector and loop for operating mains
pilot loop relay. Power requirements 240V AC. 344 x 282 x
155. Supersedes UN16/7. Sub-unit CD2L/516. SCPD 1983.
NICAM 3 Demultiplexer. This unit receives a 2048kbit/s
HDB3 bitstream and recovers clock from it. It feeds up to
three (plus spare) CD3M/33's with demultiplexed bitstreams
and shift pulses. Power requirements +5V, at 200 mA,
+18V at 100 mA, -18V at 100 mA. Parent equipment CD3M/33.
DD
1980.
DDMI
6.379(80).
EDI
10443(1)AUG82.
DDHB
6.227(83).
NICAM 3 Demultiplexer. This unit is part of the CD3M/33A.
It receives either a 338 or 676 kbit/s HDB8 bitstream and
recovers a 676kHz clock. It provides a 16MHz system clock
304

4